今天为大家带来电动门的安装流程，想了解这方面知识的朋友请关注以下内容，希望能让您有所获益。 Today we have to bring the electric door installation process, want to know this knowledge of friends, please pay attention to the following content, hope to make you benefit. 1、确定传达室内控制盒的位置，即操纵伸缩门开关的装置位置； 1. Determine the position of the indoor control box, that is, the position of the retractable door switch; 2、将220V电源引到控制盒的位置下端，要求最好是再带1根接地线，粗细规格为1.37，而且有漏电保护装置，并采用PVC暗敷； 2, the 220V power supply to the control box at the lower end of the requirements, it is best to bring 1 ground wire, the thickness specification of 1.37, and there is leakage protection device, and use PVC concealed coating; 3、预留￠32mm PVC管道，从控制盒的位置下端往下至地平面以下，穿墙往外，至轨道大致位置地平面下0.1-0.15米处，供以后伸缩门室外线路入室； 3, reserved Phi 32mm PVC pipeline, from the lower end position of the control box down to below ground level to the wall, to track the approximate position of ground plane under 0.1-0.15 meters, after the gate line for outdoor burglary; 4、按照上表得出门洞长度，砌门洞时洞宽内净空不小于0.75-0.8米，高度内净尺寸普通门不小于门高+0.25米，豪华门不小于门高+0.1米；门洞末端里侧中上端留宽0.4米，高0.6米检修孔，有条件的可将门洞总长度再加长0.2-0.3米，这样可将检修孔改成一扇小门，方便日后检修维护伸缩门电气线路； 4, in accordance with the table out the hole length, the width of clearance in masonry when the hole is not less than 0.75-0.8 meters in height, the net size is not less than the ordinary door door +0.25 meters high, luxury door door is not less than +0.1 meters high; the upper end of the left side is 0.4 meters wide, 0.6 meters high manhole, conditional the total length of the longer 0.2-0.3 meters, so Kong Gaicheng will overhaul a small door, convenient maintenance on electrical wiring gate; 5、在铺设轨道前除留下约0.8-0.9米宽外，先做好两边的地面；2-3日（冬天5-7日）后，再在铺设轨道的同时，土建配合做好轨道处的地面，注意铺设轨道期间，路面禁止通行，以免压弯轨道； 5, the installation of the track before leaving in about 0.8-0.9 meters wide, be on both sides of the ground; 2-3 (winter 5-7), then the installation of the track at the same time, cooperate with the civil track ground, pay attention to laying the track during the road closed to traffic, in order to avoid bending track;