电动车库门轨道的安装：根据门板的宽度和高度确定两轨道固定性的位置并用水平管测水平，再用M8×41㎜的方头螺钉固定。用卷尺测准水平轨与墙壁及两水平轨之间的间距，用水平尺测准水平轨的水平，然后用M6.4×14㎜的小帽螺丝和六角螺帽将水平轨连接件与水扭王块模具 高铁遮板模具 阶梯护坡模具 拱形护坡模具 卵形槽模具 保定室内设计培训 保定平面设计培训平轨和轨道固定性连接固定。用带眼角钢制成两个三角架，然后将其与水平轨的末端用M6.4×14㎜的小帽螺丝、螺帽连接，并用M8×70㎜的膨胀螺栓固定到天棚或墙壁上。
Installation of the door track of the electric garage: determine the fixed position of the two tracks according to the width and height of the door panel, measure the level with a horizontal pipe, and fix it with M8 × 41mm square head screw. Measure the distance between the horizontal rail and the wall and the two horizontal rails with a tape, measure the level of the horizontal rail with a horizontal ruler, and then use M6.4 × 14mm small cap screws and hex nuts to connect and fix the horizontal rail connector with the horizontal rail and the track fixedly. Two tripods are made of angle steel with eyes, and then they are connected with the end of the horizontal rail with M6.4 × 14mm small cap screws and nuts, and fixed to the ceiling or wall with M8 × 70mm expansion bolts.