承德电动门厂

1、预埋轨道。

1. Pre buried track.

2、固定门体：将门体放入轨道，尾部的底撑用专用固定卡及地脚膨胀螺钉（M12×80）固定。

2, the fixed door body: the door body is put into the track, the bottom support of the tail is fixed with the special fixed card and the foot expansion screw (M12 x 80).

3、限位开关：按照设定门体的开、关位置埋设限位装置。

3, limit switch: according to the opening and closing position of the set door, the limit device is embedded.

4、固定控制盒：控制盒可以装在机头箱内，也可移至离主机10米之内的室内。

4, fixed control box: the control box can be installed in the head box, and can also be moved to the room within 10 meters from the host.

5、连接线路：严格按接线图依次接好相对应的连线（严禁在通电状态下接线），接线要牢固，端子与端子之间不能短路，并捡查线路是否正确。

5, connect the line: strictly connect the corresponding connection line according to the wiring diagram strictly, (strictly prohibit the connection under the electrified state), the connection must be firm, the short circuit between terminals and terminals, and check whether the line is correct.

6、调试：

6, debug:

1）、首先用手动的方式人工推拉门体，检查门体运行是否正常，在确定门体运行正常的情况下，方可接通电源。

1) first, manually push and pull the door body manually to check the normal operation of the door body. In the case of the normal operation of the door, the power supply can be connected.

2）、接通电源，控制盒电源指示灯亮，按“开”按纽，“开”指示灯亮，门体能自动打开至设定的限位处自动停止。按“关”按纽，“关”指示灯亮，门体能自动关闭至设定的限位处自动停止。

2), connect the power control box, power indicator light, click "open" button, "open" indicator lights, door can open automatically to set the limit at the automatic stop. According to the "off" button, "off" indicator lights, door can automatically close to set the limit at the automatic stop.

3）、在调试运行过程如发现门体运行限位不准确，可调整限位开关的高度。

3), in the process of debugging, the height of the limit switch can be adjusted if it is found that the operation limit of the door is not accurate.

4）、调试运行5次以上，如一切正常方可投入使用。

4), the commissioning and operation of more than 5 times, such as all normal parties can be put into use.