承德电动门厂

The type of electric door alarm detector output signal interface for relay output interface supply voltage for DC 12 - 15V or can not be directly supply the power controller. The probe power should be less than or equal to 100 mA. According to the site condition can be used for more than one probe (generally 1 - 2 is appropriate) much the way and take probe. The probe should avoid other heat or direct light effects above should add fangyuzhao.

电动门的电缆芯数一般不应少于8线(过去有7线的接线不很合理)门体电缆中间不应含有接头.

The number of cable cores of electric door should not be less than 8 lines (there are 7 lines in the past), the cable should not be included in the middle part of the door body

遥控发射器应保持外壳好防止挤压振动跌落进水等现象.注意检查电池电压必要时及时更换.当遥控距离过近时一般应更换电池.电池型号为KC12V-23A.遥控器应尽量避开电磁干扰源.

The remote control transmitter should maintain good prevent extrusion shell vibration and drop water phenomenon. Check the battery voltage when necessary and timely replacement. When the remote control distance near generally replace the battery. Battery models for KC12V-23A. remote control should try to avoid electromagnetic interference source.

电动门报警功能的性能取决于报警探头的性能用户应根据报警的实际需要选配报警探头.DKM-2B控制器成套出厂时配一只热释型报警探头.如果不用报警功能探头不椄即可.

The performance of the user electric door alarm function depends on the properties of the alarm probe should be based on the actual needs of alarm optional alarm probe.DKM-2B controller complete factory with a heat release alarm probe. If no alarm probe can not Jie.